How I Fixed FLSUN S1 Bed Adhesion Issues and Got My Prints to Stick - A Step-by-Step Guide for Frustrated Users

Let me start by saying, if you’re someone who's been struggling with getting your prints to stick on your FLSUN S1 3D printer, you're not alone. The frustration of failed prints despite trying various methods can be maddening. But fear not, as I’m here to share with you a step-by-step guide on how I tackled this very issue successfully.

The Battle Begins

I, too, was once at my wit's end, trying everything from slowing down the first layer to using brims, rafts, glue sticks, and sprays, only to find my prints failing time and time again. It seemed like my printer was on a mission to drive me crazy. But then, I stumbled upon a series of steps that finally unlocked the secret to perfect bed adhesion.

Step 1: Camera Maintenance

First things first, ensure you clean off your cameras on the effector X2. This step is often overlooked but can significantly impact print quality and adhesion. Take the time to wipe away any dust or debris that might be hindering the cameras' functionality.

Step 2: Plate Preparation

Next, clean off the two white pads on the rear of the plate. These seemingly minor pads play a crucial role in ensuring your prints adhere properly to the bed. Neglecting this simple step can lead to adhesion issues.

Step 3: Camera Calibration

Calibrate your camera using the M100 S1 command. Proper camera calibration is essential for achieving accurate prints and ensuring the printer operates optimally. Don't skip this step if you want consistent and reliable results.

Step 4: Extruder Maintenance

Check that the extruder tip is clean and free from any debris. A clogged or dirty extruder can cause a myriad of issues, including poor adhesion. Make it a habit to inspect and clean the extruder tip regularly. a dirty tip with plastic still sittign on the sufrace will casue bed leveling issues you will be chasing and scratching your head at after each level. grab some melamine sponge, heat it up, wipe it with the dampened soponge and it's clean in 0.3 seconds

Step 5: Bed Leveling and Flow Calibration

Run the bed leveling process twice with a single command from the printer. Additionally, perform a flow calibration that runs lines up front and uses the laser to check flow. These steps are critical for ensuring proper adhesion and print quality.

The End of Frustration

While some users have reported that the bed leveling step needs to be repeated more frequently than expected, following these steps in order can make a significant difference in your printing experience. Remember, consistency is key, and taking the time to perform these maintenance tasks can save you a lot of headaches in the long run.

So there you have it - a comprehensive guide on how to fix FLSUN S1 bed adhesion issues and achieve flawless prints every time. By incorporating these steps into your routine, you'll soon bid farewell to failed prints and hello to smooth, successful 3D printing sessions.

Image: Effector cameras cleaning is essential for optimal print quality.

Remember, every journey to mastering 3D printing comes with its challenges, but with the right tools and knowledge at your disposal, success is always within reach. Keep persevering, keep experimenting, and most importantly, keep printing!

Let's conquer those adhesion issues together!